Control Of The Product Output(S) - Adeunis RF DRY CONTACTS Sigfox Guide Utilisateur

sigfox DRY CONTACTS- Guide utilisateur / User guide version V1.2.0

2.2.4 Control of the product output(s)

The product allows you to configure all or a part of the digital connections as outputs to control them from the network by a downlink frame
according to the following diagram:
The settings associated with this mode of operation are:
• The configurations of the different digital inputs (registers 302 to 305).
A complete list of the registers can be found in paragraph 3.4.
E.g.:
Register
S302
S303
S304
S305
In this example TOR2 is configured as an output with a state by default at 1.
Product in standby
Frame send 0xXX
Reception frame 0x03
Updating the digital
inputs states configu-
red as output
Value encoding
Hexadecimal
Hexadecimal
Hexadecimal
Hexadecimal
Event or
No
periode
reached ?
Yes
Value Result
0x73 Input TOR1 configuration:
• Periodic mode
• Detection of high and low edges
• Waiting* period of 1 second
0x07 Input TOR2 configuration:
• Output (Default state = 1/close)
• No waiting* period
0xB4 Input TOR3 configuration:
• Event mode
• Detection of high edges only
• Waiting* period of 20 second
0x32 Input TOR4 configuration:
• Periodic mode
• Counting of low edges only
• Waiting* period of 50 milliseconds
EN
Page 55 of 80