Outputs Page; Polarity (On Standby); Set Output Columns; Output Reserves - Bentel Profiline AZ6400 Instructions D'installation

med Telephone numbers when the associa-
ted Channel is restored to Standby.
„
Click (9 9 9 9 9 ) the check boxes
of the Telephone numbers to call. The messa-
ges will be sent to the selected (9 9 9 9 9 ) Telephone
numbers, when Events occur/end on the as-
sociated Input. Click once to toggle the status.
„ „ „ „ „
Refer to
tion. If this option has been programmed, Input No. 4
cannot be programmed to manage SMS texts.
O P
UTPUTS AGE
This page (see Figure 11) will allow you to select
the Output ; assign the
tputs; and program the Reserved Outputs, Tele-
phone Access Code and SMS Strings for remote
control (over the phone).
z
(on Standby)
(á á )
á á
á
will be present on
Alarm status. However, if a Pull-Up resistor is
connected, a Positive signal will be present.
(â â )
â â
â
be present on
Alarm status.
Click once to toggle the status.
z z z z z
Click (9 9 9 9 9 ) the check boxes of the Events that
in the sec-
to the Ou-
no signal (floating)
Output terminals during
: a Negative signal will
Output terminals during
will activate the corresponding Output, in the
event of an Alarm.
z z z z z
Click the check boxes of the Outputs that will
be dedicated to Remote Telephone Control.
Reserved Outputs can be accessed ONLY over
the phone, via the Telephone Access Code.
z z z z z
Program the SMS text that will turn ON the
Reserved Output in this field.
Each message can contain 10 characters (DO
NOT put spaces between letters).
z z z z z
Enter the Telephone Access Code (max. 4 di-
gits) in this field. For further information refer
to the 'Outputs Page'.
C P
ALL AGE
This page (see Figure 12) will allow you to view
the list of , and calls.
33