Sms Dialler Facility; Sms Communications; Priority; Gsm Interface Dialler Facility - Bentel Profiline AZ6400 Instructions D'installation

   
   
   
— , it will remain connected to the GSM
Network for a further full 15 minute interval. This
operation will be repeated until the PSTN line is
fully restored. The
during ongoing calls.
The simulated line will provide the line ring voltage
for incoming calls, and will decode DTMF dialling
(the is unable to decode Pulse
dialling).
Only the Green signal strength LEDs Y%
be during standby status.
The Red
when the telephone device (connected to the
Interface) engages the line.
The Red
when the telephone device (connected to the
Interface) receives a call on the SIM-
CARD number.
The has a seven-segment LED
display that will indicate: Programming status; Line
engaged status; Active Line (PSTN or GSM); Num-
ber called Interface mode (refer to Table 5).
The speed at which the numbers appear on the
display depends on the dialling speed of the con-
nected telephone device.
Table 4 contains the descriptions of all the LEDs
located on the frontplate.

SMS DIALLER FACILITY

The facility will send preset text mes-
sages to the programmed telephone numbers. This
facility is activated by Alarm signals on the 4 Input
Channels.
Only 2 messages can be preset for each
channel (the Activation and Restoral messages).
z z z z z
The preset SMS communication will be sent
when the associated Alarm event occurs on
the Alarm line.
will not switch
% will
% % %
LED T T will go
T T
T
LED R R will go
R R
R
ts the system from sending an SMS communi-
cation more than once for the same Alarm.
z z z z z
If several Alarm events occur
contemporarily, the SMS communications will
be sent in accordance with the
chronological order of the Alarms.
- The GSM Interface facility takes
priority over the SMS Dialler facility. Therefo-
re, if a line-sharing device (connected down-
stream to the Interface) requires the line, any
ongoing SMS communications will be interrup-
ted, and the calls from the line-sharing device
(e.g. Security system) will be sent. When the
line-sharing device hangs up, the SMS Dialler
facility will restart the communications.

GSM INTERFACE DIALLER FACILITY

G
The Dialler facility will be activated by Alarm si-
gnals on any of the 4 Input channels. Once activa-
ted, the Dialler will call the programmed telephone
numbers, and send the associated messages.
z z z z z
Voice calls will be sent when Alarm events
occur on channels that have been duly pro-
grammed with Voice messages, and at least
one telephone number.
In the event of an Alarm on one of the Input
channels, the
follows (see Figure 5).
. It will dial the first telephone number on the
It will check for the '
GSM Network '
proceeding with the call. In the event of either,
it will abort the call and go to the next telepho-
ne number. In this way no time will be lost in
dialling engaged numbers.
If the is and the
(refer to the "
it will send the associated voice message.
If the is but the
, it will end the call and go to the next tele-
phone number on the list.
The
G
seconds for a valid handshake.
This feature preven-
will perform as
list.
' tone, and
' (bad signal) before
is
" option),
is
will wait up to 40
27