Call Successful Number; Sms Dialler Page; Sms; Set Input - Bentel Profiline AZ6400 Instructions D'installation

balancing occurs on Input
call to Telephone Number 1 (if duly program-
med).
z z z z z
Select one of the following options:
„
as soon as the GSM Interface receives a voice
answer.
„
. The message will be played as
soon as the GSM Interface detects the back
ring.
„
. The message will be played as soon
as the GSM Interface finishes dialling the tele-
phone number.
z z z z z
If this option is enabled (;), answered calls
will be called again during the subsequent call
cycles.
If this option is disabled (…), answered calls
will be excluded from subsequent call cycles.
SMS D
IALLER
This page (see Figure 10) will allow you to pro-
gram all the SMS Dialler parameters.
32
, it will send a
. The message will be played
P
AGE
z z z z z
Using the SMS table, program the 8 message
texts. Each mesage can have up to 120 cha-
racters (including spaces). The chart in Figu-
re 10 shows the characters that can be used.
. Click the relevant
. Enter the message.
z z z z z
Using this table, program the parameters of
the Inputs:
„
(Normal status)
Select whether the input is to be activated by:
(á á ) - Positive signals, or
á á á
(â â ) - Negative signals.
â â
â
Click the relative Input
the status.
„
Triple-click the corresponding Input in the
field, click to open the dropdown message list,
then select the message. The selected message
will be sent to the programmed Telephone num-
bers when the assigned Channel triggers an Event.
„
Triple-click the corresponding Input in the
field, click
sage list, then select the message. The se-
lected message will be sent to the program-
$5,.0
      
  
( ) * + , - .
/ 0 1 2 3 4 5
6 7 8 9 : ; <
= D E F G H I
J K L M N O P
Q R S T U V W
X Y Z [ \ ]
text field
field to toggle
to open the dropdown mes-
³
 
! " $ % & '
µ