Programming The Sim Via Pc; Introduction; Preliminary Operations; Folders - Bentel Profiline AZ6400 Instructions D'installation

The following sections provide the relative instruc-
tions.
G G G G G

PROGRAMMING THE SIM VIA PC

This section describes the programming procedu-
re via the
(runs under Windows™), and provides a detailed
description of all the programmable parameters.
z z z z z
To access the Programming phase, proceed
as follows:
If you access 'Service' mode, via the
, the system will allow any ongoing tele-
phone call to finish, before stopping the call cycle
and activating the 'Service' mode. If the
utilized is Channel 1, any ongoing call
will be interrupted, the call cycle stopped and the
'Service' mode activated immediately.
During the Programming phase:
A PC cable (included) is required. The 3-pin con-
nector must be connected to connector [ ], and
the DB9 to the computer COM port (refer to the
' ' section for the
z z z z z
Work carefully through the following steps to
access the Programming phase:
. Turn ON the GSM Interface and wait about
20 seconds.
. Start the Software Application.
. Connect the cable.
. Put the GSM Interface in 'Service' mode, as
described at the beginning of this section.
G G G G G
The Application will open on the Main page (see
Figure 6). The Folders, Customers and Dialo-
gue windows on the left of the page (see Figu-
re 7) will allow you to program the system.
z z z z z
cess the various Pages.
z z z z z
tions, as follows:
lect the Customer.
the Database to the Hard-Disk, or
delete the Customer data from the Database.
Customers can also be Loaded by double cli-
cking the Customer name.
The Customers can be listed in alphabetical or
Code order — select
red.
z z z z z
show
information (as shown on Cellphone displays).
The Telephone, Telphone Dialler, SMS Dialler and Ou-
tputs pages will allow you to program all the system
parameters, and customize the system. The Status
and Calls pages will allow you to monitor the system.
).
The following sections describe all the GSM Inter-
face Application Pages.
T
This page (see Figure 8) will allow you to program
the Telephone numbers of the Contact persons to
call in the event of an Alarm (up to 8).
z z z z z
Using this table, program the Contact numbers:
. Click the relative box in the '
this window will allow you to ac-
this window will allow you to
or Customers configura-
Using the button on the mouse, se-
Click to load the Customer data from
this real-time window will
messages, Settings, and other
P
ELEPHONE AGE
to
or as requi-
' column.
29