Connections - Bentel Profiline AZ6400 Instructions D'installation

ble entry [ ].
. Attach the backplate to the wall.
. Insert the SIM-CARD (see Figure 2a).
G
Complete the connections on the terminal bo-
ard [10].
. Fit the antenna [ ] and connector [ ], then clo-
se the

CONNECTIONS

A detailed description of the
minals can be found in Table 3.
G G G G G
Connect the Security device telephone terminals
( ) to terminals 3-4 ( ) on the
board and, if required, connect Terminals 1-2 (
directly to the PSTN line.
The 5 OC Outputs refer respectively to terminals 7-
8-9-10 and 11 ( ,
Outputs are programmed at default to signal the even-
ts shown in Table 3. The Output signals and Standby
Polarity (
(á á ) can be programmed as per requirements.
á á á
The provides 4 Alarm channels for
SMS and Telephone Dialler functions. These chan-
.
, , and ). These
(â â ) or
â â â
$FWLYDWLRQ
&RPPDQG IRU
-XPSHU
,QSXW /LQHV
3  3
ter-
)
 7KH -XPSHU 3  VHWV WKH SRODULW\ RI /LQHV / DQG /
 7KH -XPSHU 3  LVHWV WKH SRODULW\ RI /LQHV / DQG /
nels refer respectively to terminals 15, 16, 17 and
18 ( , , and
Positive signals (transition from M
or Negative signals (transition from positive to M
â).
Use the on-board Jumpers P2 [
set the standby polarity of Input pairs
(refer to Table 2). This setting is strictly
linked to the Input standby polarity (refer to "
6HWWLQJV
3URJUDPPLQJ
9LD 6RIWZDUH
,
,
-
-
), and can be activated by
M M M to Positive á) M
] and P3 [
0DQXDO
/ / / /
+ + + +
+ + + +
/ / / /
M M
M M
] to
and
25