Priority Channel; Activating Reserved Outputs Via Sms; Programming The Gsm Interface - Bentel Profiline AZ6400 Instructions D'installation

. It will repeat the message 4 times before en-
ding the '
The call will be considered 'Successful' after
the second message announcement.
G
G The Input channel cannot generate further
call cycles until it has been restored to standby.
z
contemporarily Alarms, channel 1 will take prio-
rity, and Channel 1 calls cycle will be sent
first. The other channels will be dealt with
chronologically.
- The GSM Interface facility takes
priority over the Voice Dialler facility. Therefo-
re, if a line-sharing device (connected down-
stream to the Interface) requires the telepho-
ne line, any ongoing Voice Dialler facility calls
will be interrupted, and the calls from the line-
sharing device (e.g. Security system) will be
sent. When the line-sharing device hangs up,
the Voice Dialler facility will restart the inter-
rupted calls.

ACTIVATING RESERVED OUTPUTS VIA SMS

The GSM Interface can be set up to control one or
3KDVH 
'LDO 1XPEHU
28
' call.
- If several Alarms occur
0D[LPXP  WULHV SHU
7HOHSKRQH QXPEHU
'LDO QH[W 7HOHSKRQH 1XPEHU
$ERUW &DOO
3KDVH 
'LDO QH[W 7HOHSKRQH 1XPEHU
more of the 5 Outputs via SMS. The communica-
tion text must include the Access code, Output
String and the required action (On/Off), as fol-
lows:
# # # # # Code# # # # # String= O N = O N = O N = O N
= O N
# # # # # Code# # # # # String= O F F = O F F = O F F = O F F = O F F
The Access Code can have up to 4 alphanumeric
characters (including spaces), whereas, the String
can have up to 10. The
the telephone pad in the
in the '
The following example shows an SMS communica-
tion that will turn ON the HEATING system (Access
code PR73).
# P R 7 3 # H E A T I N G = O N # P R 7 3 # H E A T I N G = O N # P R 7 3 # H E A T I N G = O N # P R 7 3 # H E A T I N G = O N # P R 7 3 # H E A T I N G = O N
Some GSM Networks provide feedback
messages to confirm that SMS communications
have been received. If this service is not available,
you can set up one of the Input channels to provi-
de the feedback message. For further details re-
fer to the '

PROGRAMMING THE GSM INTERFACE

G G G G G
(QG &DOO
12
3KDVH  3KDVH 
must be entered on
as it is written
' column on the '
' section.
(QG &DOO
' page.