Connecting With Cleaner; Concerning Cutting Of Stainless Steel Plates - Hitachi CJ 14DSL Mode D'emploi

6. Angular cutting
The base can be swiveled to both sides by up to
45° for angular cutting. (Fig. 21)
(1) Loosen the base bolt by allen wrench attached on
base and move the base fully forward. (Fig. 16,
17)
(2) Align the scale (from 0 degrees to 45 degrees by 15-
degree increments) of the semi-circular part of the
base with the [ ] mark on the gear cover. (Fig. 22)
(3) Tighten the M5 bolt again. (Fig. 16)
(4) Set the orbital position to "0".
NOTE:
Angular cutting can not be done when adopting
chip cover or dust collector.
Base
Semi-
circular part

CONNECTING WITH CLEANER

By connecting with cleaner (sold separately) through
dust collector (sold separately) and adapter (sold
separately), most of dust can be collected.
(1) Remove the allen wrench from the base.
(2) Move the base fully forward. (Fig. 16, 17)
(3) Attach the chip cover.
(4) Connect the dust collector with adapter. (Fig. 23)
(5) Connect the adapter with the nose of cleaner. (Fig.
23)
Fig. 21
-mark
Scale
Fig. 22
(6) Insert dust collector into the rear hole of the base
until the hook catches in the notch. (Fig. 24)
(7) Press the hook to remove the dust collector.
NOTE:
Wear the dust mask additionally, if available.
Chip
cover
Base
Dust
collector
Notch
Base
Rear
hole Dust
CONCERNING CUTTING OF STAINLESS
STEEL PLATES
CAUTION:
In order to prevent blade dislodging, damage or
excessive wear on the Plunger, please make sure to
have surface of the base plate attached to the work
piece while sawing.
When cutting stainless steel plates, adjust the unit as
described below:
1. Adjust the speed
Blade Thickness of material
1/16" – 5/32"
No. 97
(1.5 – 2.5 mm)
NOTE:
The higher the speed is, the quicker the material is
cut. But the service life of the blade will be reduced
in this case. When the speed is too low, cutting
will take longer, although the service life will be
prolonged. Make adjustments as desired.
English
Nose Cleaner
Adapter
Fig. 23
Hook
Nose
collector Adapter
Fig. 24
Speed
Middle speed
17