Led Display - Wilo Stratos MAXO Notice De Montage Et De Mise En Service

en-US
Ite Designation Explanation
m
Switches on or off in combination with the
back key lock. > 5 s.

LED display

Provides information about error codes and
5.1
Bluetooth PIN.
LED display Initiates venting function when pressed.
5.2 operating Turning is not possible.
button
Table 6: Description of operating elements
Pump settings
Adjust settings by pushing and turning the operating button.
Turn : Selection menus and set parameters.
Push : Activate menus or confirm selected parameters.
Initial settings menu
The initial settings menu appears in the display on initial commis-
sioning of the pump.
▪ Stratos MAXO/ Stratos MAXO-D: The pump runs with factory set-
tings ➜ Application: radiators; control mode: Dynamic Adapt plus.
▪ Stratos MAXO-Z: The pump runs with factory settings ➜ Applica-
tion: drinking water circulation; control mode: Temperature T-
const.
20
WELCOME - WILO-STRATOS MAXO
Start with factory settings
Pump works for radiator
Start venting
Automatic procedure
Initial settings
for commissioning
Fig. 1: Initial settings menu
If necessary, change the language using the context key
language settings menu.
The pump runs on factory settings while the initial settings menu is
being displayed.
▪ Activate "Start with factory settings" by pressing the operating
button to leave the initial settings menu. The display switches to
the main menu. The pump continues to run on factory settings.
▪ You can adjust further settings even once venting has been started.
▪ You can use the "Initial settings" menu to select and set features
such as the language, units, applications and night setback. Confirm
the selected initial settings by activating "Quit initial settings". The
display switches to the main menu.
The pump has been
successfully installed!
Pump currently running on
factory settings:
Application:
Radiator
Control mode:
Dynamic Adapt plus
via the
WILO SE 2019-08