Servicing The Tool; Servicing; Service Kit - Avdel 74405 Manuel D'instructions

S e r v i c i n g t h e To o l
S e r v i c i n g
Regular servicing should be carried out and a comprehensive inspection performed annually or every 500,000 cycles, whichever is
sooner.
The employer is responsible for ensuring that tool maintenance instructions are given to the appropriate personnel.
The operator should not be involved in maintenance or repair of the tool unless properly trained.
D a i l y
•
Daily, before use or when first putting the tool into service, pour a few drops of clean, light lubricating oil into the air inlet of the tool. If the
tool is in continuous use, the air hose should be disconnected from the main air supply and the tool lubricated every two to three hours.
•
Check for air leaks. If damaged, hoses and couplings should be replaced by new items.
•
If there is no filter on the pressure regulator, bleed the air line to clear it of accumulated dirt or water before connecting the air hose to the
tool.
•
Check that the nose assembly is correct.
•
Check the stroke of the tool is adequate to place selected insert (see Stroke Adjustment page 8).
•
Inspect the drive screw in the nose assembly for wear or damage. Renew, if necessary.
We e k l y
•
Check for oil leaks and air leaks on air supply hose and fittings.
For all servicing we recommend the use of the Service Kit, part number 74405-99990, detailed below.

SERVICE KIT : 74405-99990

PART Nº
07900-00618 PUSHER
07900-00409 12mm/13mm SPANNER
07900-00632 17mm/19mm SPANNER
74200-12196 17mm THIN SPANNER
07900-00642 27mm/30mm SPANNER
07900-00859 42mm SPANNER
07900-00158 Ø2mm PIN PUNCH
07900-00624 Ø4mm PIN PUNCH
07900-00469 2.5mm ALLEN KEY
07900-00351 3mm ALLEN KEY
07900-00224 4mm ALLEN KEY
07900-00225 5mm ALLEN KEY
07900-00226 6mm ALLEN KEY
Grease used during tool maintenance can be ordered as a single item, the part number is shown in the Service Kit above.
I M P O R T A N T
Read safety instructions on page 4.
The tool shall be examined regularly for damage and malfunction.
DESCRIPTION Nº OFF PART Nº
1 07900-00521 Ø1/4" ROD
1 07900-00639 NYLON BUSH
2 07900-00640 METAL BUSH
1 07900-00161 EXTERNAL CIRCLIP PLIERS
1 07900-00157 INTERNAL CIRCLIP PLIERS
1 07900-00625 SOFT MALLET
1 07900-00426 COMBINATION SPANNER
1 07900-00860 BULLET
1 07900-00717 SPANNER FOR INTENSIFIER
1 07900-00692 TRIGGER VALVE EXTRACTOR
1 07992-00020 GREASE - MOLY LITHIUM EP3753
GREASE - MOLYKOTE ® 55M
1 07992-00075
GREASE - MOLYKOTE ® 111
1 07900-00775
DESCRIPTION Nº OFF
1
1
1
1
1
1
1
1
1
1
1
1
1
11