Fitting Instructions - Avdel 74405 Manuel D'instructions

F i t t i n g I n s t r u c t i o n s
It is essential that the correct nose assembly is fitted prior to operating the tool. By knowing your original complete tool part number
or the details of the fastener to be placed, you will be able to order a new complete nose assembly using the datasheet 07900-
00857 for nose assembly components.
The air supply must be disconnected when fitting or removing nose assemblies unless specifically instructed
•
If still fitted remove the nose casing and adaptor nut.
•
Insert Drive Shaft 4 into spindle.
•
Fit Drive Screw 3 onto Drive Shaft 4.
•
Insert Reducing Sleeve 5 (if required) into the adaptor nut.
•
Position Friction Ring 51* onto the spindle.
•
Screw the adaptor nut onto the spindle.
•
Hold the spindle with a spanner*, tighten the lock nut anti-clockwise, ensuring the friction ring is not caught between the faces of the
spindle and the adapter nut.
•
Screw on the nose casing together with Nose Tip 1 and nose tip Lock Nut 2.
•
The reverse operation is carried out for equipment removal.
•
With tool still disconnected from air supply, screw one insert onto the drive screw manually making sure the insert is flush with the end of
the drive screw.
•
Set nose tip in exact position and lock nose tip nut clockwise with a spanner*.
•
Remove the insert from the drive screw.
(Item numbers in bold refer to illustration below, 51* refers to illustration on page 16).
LOCK NUT
ADAPTOR NUT
* Item included in the 74405 Service Kit. For complete list see page 11.
I M P O R T A N T
The Nose Assembly must be fitted before operating the tool.
I M P O R T A N T
otherwise.
51
SPINDLE FRICTION RING
NOSE CASING
*
4
3
* Items in grey are included in the base tool.
5
2
1
9