Cleaning And Storing The Device - DS Produkte 02450 Mode D'emploi

EN

Cleaning and storing the device

ATTENTION!
■ Before you clean the device, always pull the mains plug out of the socket.
■ Keep the motor unit (2), the mains cord (E) and the mains plug away from water or
other liquids to prevent electrical shocks. Always take the dust bin (1) off of the motor
unit (2) before cleaning.
■ Accessories that are cleaned with water must be completely dry when inserting them
in the device!
■ The fi lters are not suitable for the washing machine, dishwasher or dryer. Only air dry
the fi lters; do not in any case use a hair dryer!
■ Do not use any sharp or abrasive cleaners or cleaning pads. They could damage the
surfaces.
The fi lters may discolour over time. This is normal and does not affect the func-
tionality.
If the fi lters are damaged or worn, new fi lters can be ordered via
www.service-shopping.de.
Emptying the dust bin
Cleaning the fi lters
1. Empty the dust bin (1) (see above).
1. Push the release button (A) for the dust bin. Take the dust
bin (1) off of the motor unit (2).
2. Hold the dust bin (1) over an open rubbish bin. The dis-
tance to the rubbish bin should be as small as possible so
that the dust does not disperse in the surroundings.
3. Pull the latch on the bottom hatch (G) down. The bottom
hatch (F) will open and the dirt will fall out.
4. Close the bottom hatch (F). The fastener must audibly lock
into place.
2. Turn the lid of the dust bin (J) slightly anticlockwise and
then lift it off.
J
3. Take the fi lter holder (K) off of the cyclone insert (H).
K
K
H
5. Carefully take the cyclone insert (H) out of the dust bin (1).
6. Knock all parts out over a rubbish bin and brush them off
1
if necessary. Rinse them off with clean water if necessary.
ATTENTION: Do not use any detergent!
Then let them dry completely. Do not assemble when
wet or damp!
20
4. Pull the foam fi lter (L) out of the fi lter
L
holder (K). The fl eece fi lter is secure-
ly attached to the fi lter holder (K)
and cannot be removed!