Cleaning The Device And Accessories; Technical Data - DS Produkte TS-18439 Mode D'emploi

EN
After Use / Cleaning the Device and Accessories
CAUTION!
■ Empty both water tanks after each use of the device to prevent deposits in the water
tanks and any damage to the device resulting from this!
■ Never immerse the motor unit in water or other liquids to avoid an electric shock!
■ Do not use any sharp or abrasive cleaning agents or cleaning pads. These could
damage the surfaces.
1. Detach the cleaning cloth (1) from the cleaning attachment (5) and wash it in accord-
ance with the specifi cations on the washing label.
2. Empty the dirty water tank (17) and, if there is heavy soiling, rinse it out:
– Pull out its sealing cap (18) and allow all the remaining water to run into a drain.
– Then reinsert the sealing cap (18).
– Suck up clear water using the suction function (see the "Use" chapter) and then
pour it away again. Repeat this process if necessary.
3. Open the fresh water tank (16) and empty it completely.
4. Pull the cleaning attachment (5) off the motor unit (2), then rinse it using clear water.
5. Wipe down the motor unit (2) if necessary with a soft, damp cloth and then dry it with
a soft cloth.
6. Allow all parts to dry in the air before storing away the device. Leave the water
tanks (16, 17) open to prevent mould from forming.
7. Charge up the battery after each use (see the "Charging Up the Battery" chapter).
8. Store the device in a dry, cool indoor room out of the reach of children and animals.

Technical Data

Article number:
Device
Model number:
Voltage supply:
Motor power:
Capacity of both water tanks: 100 ml
Battery charge time:
Battery operating time:
Mains adapter
Model number:
Voltage supply:
Output:
Protection class:
20
03429
TS-18439
3.7 V DC, Li-ion battery 1500 mAh
10 W
approx. 4 – 6 hours; fi rst charge approx. 10 – 12 hours
approx. 30 minutes (with fully charged battery)
XS-050050EU
100 – 240 V ~; 50 /60 Hz; 0.3 A
5 V 500 mA
II