Cleaning And Storage - DS Produkte PC-P008E Mode D'emploi

2. Switch the device on. This can be done in one of two ways:
– by gently holding the On / Off switch (1) down. The device will switch off when you
let it go.
– by fi rmly pushing the On / Off switch once and then releasing it. If you would like to
switch the device back off, push the On / Off switch again.
3. The device will immediately start to vacuum clean. The operating lamp and the
battery charges status lamps are lit up.
4. Run the device over the area to be cleaned.
5. If the articulated suction tube is to be bent, press the release button on the articulated
suction tube and bend the lower part forwards.
If it is to be folded up again, move the lower part back into the straight position. The
release button must be heard to engage in place.
6. After vacuuming, switch off the device.
7. To ensure that the device operates optimally, empty and, if necessary, clean the dust
container (5) after each use (see the next chapter).

Cleaning and storage

PLEASE NOTE!
■ Do not immerse the HEPA fi lter and the foam fi lter in water or rinse it under running
water to prevent damage. They are neither machine-washable, dishwasher-safe
nor suitable for tumble drying.
■ The fi lter holder is not suitable for the washing machine, dishwasher or dryer! Only
air dry the fi lter holder and do not in any case use a hair dryer.
■ Do not use any corrosive or abrasive cleaners to clean the housing. They could
damage the surface.
The HEPA fi lter may lose some of its colour over time. This is normal and
does not have any adverse effect on function.
Emptying the Dust Container and Cleaning the Foam Filter
closed
open
e
27
1. Remove the dust container (5) from the motor unit (10).
Turn it a little to do this. It is released from the motor unit
and can be removed.
2. Remove the foam fi lter from the top of the dust container,
tap it out and clean it with a soft brush if necessary.
3. Hold the dust container over an open dust container. The
distance from the dust container should be as small as
possible so that the dust does not spread in the surroun-
ding air.
4. Pull the catch of the bottom fl ap (e) away from the dust
container slightly. The bottom fl ap will open and the dirt
will fall out.
5. To close it, press the bottom fl ap onto the dust container.
The catch must be heard to engage in place.
EN