DS Produkte PC-P008E Mode D'emploi page 28

EN
Cleaning the HEPA fi lter and the fi lter holder
1. Empty the dust container (5) (see above). Do not close the bottom fl ap (e).
2. Reach into the dust container. Turn the fi lter holder (g) a little until it is released and
can be removed.
f
7. Let all parts dry completely in the air before you reassemble them. NOTICE: Never
assemble wet or damp components or attach them to the motor unit (10)! The
device is assembled in the reverse order.
Cleaning the Motor Unit, Articulated Suction Tube, suction hose and
Nozzles
• Wipe down the motor unit (10), articulated suction tube, suction hose and nozzles
with a damp, soft cloth if necessary. Then dry them with a soft cloth.
• Regularly remove hair and fl uff from the nozzles and brushes.
• Remove the dust cloth from the dusting mop attachment and wash it as per the
washing instructions.
Cleaning the Electrical Floor Nozzle
To make it easier to clean, the brush can be removed from the electrical fl oor nozzle:
Storage
• Store the device in a cool, dry place which is protected from direct sunlight and is out
of the reach of children and animals.
• For easy storage, attach the device with its suction opening (3) facing downwards on
the wall bracket which is supplied.
If you do not want to use the device for a prolonged period, remove the recharge-
able battery (7) to stay on the safe side (see section "Charging the rechargeable
battery").
3. Pull the HEPA fi lter (f) out of the fi lter holder.
4. Tap out both parts and clean them with a soft brush if
g necessary.
5. The fi lter holder can also be rinsed with clear water.
NOTICE: Do not wet-clean the HEPA fi lter!
6. Wipe out the dust container with a damp cloth if necessary.
1. Slide the latch fastener on the bottom of the electrical
fl oor nozzle towards the small wheel on the electrical
fl oor nozzle.
2. Open and remove the latch.
3. Take out the brush and remove any contamination.
4. Reinsert the brush. When you do this, fi rst insert the end
with the star-shaped recess.
5. Insert the latch and slide the latch fastener back in place.
28