Troubleshooting - DS Produkte 02450 Mode D'emploi

7. Assemble the parts as follows once they are clean and dry:
a) Put the cyclone insert (H) back in the dust bin (1). Make sure that the three catches
on the edge of the cyclone insert (H) are fi tted into the corresponding recesses in
the dust bin. They have different sizes.
b) Insert the foam fi lter (L) in the fi lter holder (K) and place it on the cyclone insert (H).
c) Place the lid (J) on the dust bin (1) so that the marking line on the edge of the lid is
located next to the
d) Turn the lid clockwise up to the stop point towards the
e) Place the dust bin (1) on the catch located in the bottom area of the motor unit (2).
Then push the dust bin (1) against the motor unit (2) until both parts lock into place
and are securely connected.
Cleaning the motor unit and attachments
• If necessary, wipe the motor unit (2) and the attachments off with a soft, damp cloth.
Dry with a soft cloth.
• Regularly remove hair and lint from the nozzles.
• Take the dust cloth off of the dust mop (15) and wash it according to washing instruc-
tions.
Storage
Store the device in a cool, dry place not exposed to direct sunlight and out of the reach
of children and animals.

Troubleshooting

If the device is not working properly, please check whether you are able to rectify the
problem yourself fi rst.
Do not attempt to repair a defective electrical device yourself!
Problem
The device is not
working.
The suction power
is weak.
symbol on the dust bin (1).
Potential cause/solution
• Is the mains plug properly connected with the socket? Cor-
rect the position of the mains plug.
• Is the socket defective? Try another socket.
• Check the fuse of the mains connection.
• Is the dust bin (1) too full?
• Are the fi lters or the cyclonic insert (H) heavily laden with
dirt? Clean as described in the chapter "Cleaning and storing
the device".
• Are the attachments plugged?
• Has the dust bin (1) been closed or inserted improperly?
21
symbol.
EN