Use - DS Produkte 02450 Mode D'emploi

2. Choose one of the following attachments and connect it to adapter 1 (3):
– large crevice nozzle (4),
– large brush nozzle (5),
– telescoping tube (13),
– adapter 2 (6) for the small attachments or
– dust mop (15).
3a. The following attachments can be connected to the telescoping tube (13):
– fl oor nozzle (14):
– dust mop (15),
– large crevice nozzle (4) and
– large brush nozzle (5).
3b. The following parts are attached to adapter 2 (6):
– all small nozzles,
– the angle piece (7) or
– the extension tubes (8).
Adjusting the length of the telescoping tube

Use

ATTENTION!
■ Only turn on the device once it has been ensured that the dust bin (1) and the fi l-
ter (H) have been correctly inserted.
■ Always switch the device off before you change the accessories.
■ Do not in any case vacuum up the following things:
– liquids or wet substances (e.g. wet carpet shampoo)
– smouldering ashes, cigarette butts, matches etc.
– fl ammable or ignitable materials
– very fi ne dust (e.g. cement dust), ash or toner
– pointed, hard objects such as larger glass shards
■ Empty the dust bin (1) if it has been fi lled up to the MAX mark to prevent the motor
from overheating (see chapter "Cleaning and storing the device").
1. Depending on your needs, choose accessories (see chapter "Device overview", sec-
tion "Accessories") and attach them to the device (see chapter "Assembly").
2. Unwind the mains cord (E) to its full length and insert the mains plug in an easily
accessible socket.
3. Tilt the On/Off switch to position 1 to switch the device on.
4. Move the nozzle over the surface you want to clean.
5. Once you are fi nished vacuum cleaning, fl ip the On/Off switch to position 0 and pull
the mains plug out of the socket.
6. To ensure that the device operates optimally, empty and, if necessary, clean the dust
bin (1) after each use (see the next chapter "Cleaning and storing the device").
19
1. Push the slider on the telescoping tube (13) and set the
desired length.
2. Release the slider and continue to move the tube slightly
until it locks into place.
EN