Driving Screws; General Maintenance - Ryobi Pcl212 Manuel De L'opérateur

INSTALLING/REMOVING BITS
See Figures 3 - 4, pages 9 - 10.
For use with only bits with 1/4" hex shank connection.
„ To install bits, remove the battery pack from the tool.
„ Push the bit into the collet until it clicks into place.
NOTE: If the bit does not insert easily into the collet, pull
the collet forward and reinsert the bit.
„ Pull on the bit to make sure it is secured in the collet.
There may be some play in the installed bit; this is normal.
NOTE: Use only 1/4" hex shank bits with a locking groove.
WARNING:
Make sure the bit is secured in the collet before using
the screwdriver. Failure to do so could cause serious
personal injury.
„ To remove bits, remove the battery pack from the tool.
„ With the nose of the tool pointed away from you, pull the
collet away from the driver.
„ The bit will eject from the collet.

DRIVING SCREWS

See Figure 5, page 10.
„ Check the direction of rotation selector for the correct
setting (forward or reverse).
„ Secure the workpiece in a vise or with clamps to keep it
from turning as the bit rotates.
„ Hold the tool firmly and place the bit at the point to be
drilled, or where the screw is to be driven.
WARNING:
When servicing, use only identical replacement parts.
Use of any other part could create a hazard or cause
product damage.
NOTE: ILLUSTRATIONS START ON PAGE 9 AFTER
OPERATION
MAINTENANCE
FRENCH AND SPANISH LANGUAGE SECTIONS.
WARNING:
Do not drive a screw where there is likely to be hidden
wiring behind the surface. Contact with a "live" wire will
make exposed metal parts of the tool "live" and possibly
shock the operator. If you must drive a screw where hid-
den wire may be present, always hold tool by insulated
gripping surfaces (handle) when performing the operation
to prevent a shock to the operator.
„ Depress the switch trigger to start the tool.
„ Move the bit into the workpiece, applying only enough
pressure to keep the bit cutting or driving the screw. Do
not force the tool or apply side pressure to elongate a
hole. Let the tool do the work.
„ With hard, smooth surfaces, use a center punch to mark
the desired hole location. This will prevent the bit from
slipping off-center as the hole is started.
„ If the bit jams in the workpiece or if the tool stalls, stop
the tool immediately. Remove the bit from the workpiece
and determine the reason for jamming.
NOTE: This tool has an electric brake. When the switch
trigger is released, the collet stops turning. When the brake
is functioning properly, sparks will be visible through the
vent slots on the housing. This is normal and is the action
of the brake.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and can be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
7 − English