Ryobi PCL212 Manuel De L'opérateur page 6

WARNING:
Do not allow familiarity with tools to make you care-
less. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always remove battery pack from the tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1, along with hearing protection.
Failure to do so could result in objects being thrown into
your eyes and other possible serious injuries.
WARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this tool. The use of
attachments or accessories not recommended can result
in serious personal injury.
HIGH TEMPERATURE PROTECTION
Li-ion battery packs are equipped with a high temperature
protection feature that automatically deactivates the tool
when it is overheated. To resume operation, allow the tool
to cool and then squeeze the trigger.
OVERLOAD PROTECTION
When the tool is forced or the motor is overloaded, the tool
will automatically shut off. To reset the tool, release the trigger
and resume operation. If the tool still does not resume opera-
tion, remove and reinsert the battery. Do not force the tool.
APPLICATIONS
You may use this tool for the purposes listed below:
„ Driving screws with screwdriver bits
„ Light-duty drilling
TO INSTALL/REMOVE BATTERY PACK
See Figure 1, page 9.
„ Lock the switch trigger.
„ Insert the battery pack into the product as shown.
„ Make sure the latches on each side of the battery pack
snap in place and that battery pack is secured in the
product before beginning operation.
„ Depress the latches to remove the battery pack.
OPERATION
For complete charging instructions, see the operator's manu-
als for your battery pack and charger.
VARIABLE SPEED SWITCH TRIGGER
See Figure 2, page 9.
The screwdriver has a variable speed switch for operator
control of speed and torque limits.
Depress the switch trigger all the way for maximum speed
and torque. Depress the switch trigger only part of the way
for less speed and torque.
Avoid running the tool at low speeds for extended periods
of time. Constant use at low speeds may cause overheating.
If this occurs, cool the screwdriver by running it without a
load and at full speed.
NOTE: A whistling or ringing noise coming from the switch
during use is a normal part of the switch function.
LED WORKLIGHT
The LED light located on the front of the tool base illuminates
when the switch trigger is depressed. If the tool is not in use,
the time-out feature will cause the light to shut off. The LED
worklight illuminates only when there is a charged battery
pack in the tool.
DIRECTION OF ROTATION SELECTOR
(FORWARD/REVERSE/CENTER LOCK)
See Figure 2, page 9.
The direction of bit rotation is reversible and is controlled
by a selector located above the switch trigger. With the
screwdriver held in normal operating position, the direction
of rotation selector should be positioned to the left of the
switch trigger for forward motion. The direction is reversed
when the selector is to the right of the switch trigger.
Setting the direction of rotation selector in the OFF (center
lock) position helps reduce the possibility of accidental start-
ing when not in use.
NOTICE:
To prevent gear damage, always allow the collet to
come to a complete stop before changing the direction
of rotation.
To stop the screwdriver, release the switch trigger and allow
the collet to come to a complete stop.
NOTE: The screwdriver will not run unless the direction of
rotation selector is pushed fully to the left or right.
WARNING:
Battery tools are always in operating condition. Lock the
switch when not in use or carrying at your side, when
installing or removing the battery pack, and when install-
ing or removing bits.
6 − English