Display Functions; Battery Removal - Sharp Bk-Cm03 Manuel D'utilisation

6
charge indicator
The Assisted Pedalling
This electric bicycle is equipped with an "assisted pedalling system",
consisting of a motor, a battery and a speed sensor.
It is important to know that when the system is on, the engine undertakes
to supply energy only while you are pedalling. When you stop pedalling,
the motor switches off and the electrical assistance for pedalling is missing.
In all pedal-assisted bicycles the engine switches off and the electrical
assistance stops when the maximum speed allowed for electric bicycles of
25 km/h is reached.
When the speed drops below this value, the electrical assistance starts
again until you stop pedalling.
Switch on e-bike by long press

Display functions:

1
1. "ON/OFF" power button – Turns the bicycle on and off
2. "F-E" LEDs – Indicate the immediate battery capacity.
3. "+/–" button – Selects pedal assistance
Level 1
Level 2
Level 3
Level 4
Level 5
The pedal assistance system is on by pressing the "ON/OFF" button. The
assistance level is reset to "1", the lowest.
To change it: start pedalling and stabilize your speed; press the "+ / – "
buttons to choose the required assistance.
button on the display to activate.
3
2
3
Walk Assist mode:
Pressing and holding the "–"button for 3 seconds activates Walk-Assist
Mode.
Change gears
Use the twist grip on the right side of the handlebars to operate the rear
derailleur. A gear engaged indicator, gear selected, is visible next to the
rotating handle.
To operate the derailleur with a twist grip, follow these steps:
a. Press the pedals forward.
b. Turn the ring (1) by hand clockwise to shift to a smaller sprocket, where
the pedaling effort will be greater.
c. Turn the gear shift ring by hand counterclockwise to move to a larger
gear, where the pedaling effort will be less.
Light operation
Lighting is one of the basic elements of bicycle user safety and it must be
installed. If you intend on riding in low visibility conditions, make sure that
the lighting works properly.
The bike is equipped with front and rear lights powered by AAA batteries.
To turn them on, press the button on the light.
Batteries are a product deemed to be dangerous, after use should be
discarded in a container assigned to it.

Battery removal

a. Make sure the bike is securely positioned on the rack. Turn the red
switch to the OFF - 0 position.
b. Turn the key counterclockwise to the "OPEN" position.
c. Hold the battery pack firmly and pull it back using the handle on the
bottom. It is recommended to hold the battery with both hands.
1