Makita GA037G Manuel D'instruction page 16

1. Open the lid on the tool as shown in the figure.
► 1. Lid
2. Insert the wireless unit to the slot and then close the lid.
When inserting the wireless unit, align the projections
with the recessed portions on the slot.
► 1. Wireless unit 2. Projection 3. Lid 4. Recessed
portion
When removing the wireless unit, open the lid slowly.
The hooks on the back of the lid will lift the wireless unit
as you pull up the lid.
3
1
2
► 1. Wireless unit 2. Hook 3. Lid
After removing the wireless unit, keep it in the supplied
case or a static-free container.
NOTICE:
the lid when removing the wireless unit. If the
hooks do not catch the wireless unit, close the lid
completely and open it slowly again.
1
Tool registration for the vacuum
cleaner
NOTE: A Makita vacuum cleaner supporting the
wireless activation function is required for the tool
registration.
NOTE: Finish installing the wireless unit to the tool
before starting the tool registration.
NOTE: During the tool registration, do not pull the
switch trigger or turn on the power switch on the
vacuum cleaner.
NOTE: Refer to the instruction manual of the vacuum
cleaner, too.
1
If you wish to activate the vacuum cleaner along with
2
the switch operation of the tool, finish the tool registra-
tion beforehand.
3
1.
tool.
2.
4
"AUTO".
► 1. Stand-by switch
16 ENGLISH
Always use the hooks on the back of
Install the batteries to the vacuum cleaner and the
Set the stand-by switch on the vacuum cleaner to
1