Connecting A Vacuum Cleaner - Makita GA037G Manuel D'instruction

Masquer les pouces Voir aussi pour GA037G:

Manuel d'instructions (168 pages)

Table Des Matières

Table des Matières

Les langues disponibles

Installing wire wheel brush

Optional accessory

CAUTION:

Do not use wire wheel brush that

is damaged, or which is out of balance. Use of

damaged wire wheel brush could increase potential

for injury from contact with broken wires.

CAUTION:

ALWAYS use guard with wire

wheel brushes, assuring diameter of wheel fits

inside guard. Wheel can shatter during use and

guard helps to reduce chances of personal injury.

► 1. Wire wheel brush

Remove the battery cartridge and place the tool upside

down allowing easy access to spindle.

Remove any accessories on spindle. Thread wire wheel

brush onto spindle and tighten with the wrenches.

Installing offset diamond wheel

Optional accessory

With optional accessories, you can use this tool for

planing concrete surface.

WARNING:

For offset diamond wheels that

are 7 mm (9/32") or thinner, place the convex

section of the lock nut upwards and attach to the

spindle.

CAUTION:

Dust collecting wheel guard for the

offset diamond wheel is only for use in planing

concrete surface with a offset diamond wheel. Do

not use this guard with any other cutting acces-

sory or for any other purpose.

CAUTION:

Before operation, make sure that

a vacuum cleaner is connected to the tool and

turned on.

Remove the battery cartridge and install the dust col-

lecting wheel guard for the offset diamond wheel.

Mount the inner flange onto the spindle. Fit the offset

diamond wheel on the inner flange and tighten the lock

nut onto the spindle.

► 1. Lock nut 2. Convex section 3. Offset diamond

wheel 4. Inner flange 5. Spindle 6. Dust collecting

wheel guard for the offset diamond wheel 7. Shaft

lock