Air Pump Mode - Parkside Pka 20-Li C3 Instructions D’origine

2. Attach: Place the valve connection
(13) onto the valve or adapter (18).
Detach: Remove the valve connec-
tion (13) from the valve or adapter
(18).
3. Close the lever (12).
Beach articles and balls
1. Select the appropriate adapter (18).
2. Attach the valve connection (13) to
the adapter (18).
3. Remove the valve cap.
4. Insert the adapter (18) into the valve.
5. Next: see Inflating
6. Pull the valve connection (13) with
adapter (18) out of the valve.
7. Put the valve cap back on.
8. Detach the valve connection (13)
from the adapter (18).
Car tyres and bicycle tyres
1. Remove the valve cap.
2. If necessary: Screw the adapter for
bicycle valves (c) onto the valve.
3. Attach the valve connection (13) to
the car valve or the adapter for bi-
cycle valves (c).
4. Next: see Inflating
5. Detach the valve connection (13)
from the car valve or from the ad-
apter for bicycle valves (c).
6. If necessary: Remove the bicycle
valve adapter (c) from the valve.
7. Screw the valve cap back on.
Inflating
1. Press the On/Off switch (4).
The device is ready for use.
2. Set to the desired pressure.
3. Press the toggle switch (6)
towards compressor mode.
The inflatable article is inflated until
the set pressure is reached.
4. Cancel the pumping process: Set the
toggle switch (6) to the middle posi-
tion.

Air pump mode

Air pump mode is suitable for filling and
deflating large-volume inflatable art-
icles, such as air mattresses, paddling
pools etc.which are filled or emptied at
low pressure.
Requirements
• The device is switched on.
• The toggle switch (6) is set to air
pump mode.
• The hose (16) is mounted.
Inflating (Fig. A)
1. Remove the valve cap.
2. Fig. A: Attach the hose (16) onto the
air outlet (15). Lock the hose in a
clockwise direction.
3. Insert the hose (16) into the valve of
the inflation article.
For 8 mm valves you need the hose
adapter (17).
4. Press the On/Off switch (4).
The device is ready for use.
5. Press the toggle switch (6)
towards air pump mode.
The inflatable article is inflated.
6. Once the desired filling volume is
reached, set the toggle switch (6) to
the middle position.
7. Pull the hose out of the valve of the
inflatable article.
GB MT
37