Description Of Functions; Technical Data - Parkside Pka 20-Li C3 Instructions D’origine

GB MT
19 Battery
20 Button Charge level indicator Bat-
tery
21 Charge level indicator
22 Battery release
23 Battery charger
Fig. B
24 Air inlet

Description of functions

As a compressor for inflating motorbike,
bicycle and car tyres and inflatable toys,
sports and beach articles.
As an air pump for inflating and deflating
large-volume inflatable items for house-
hold use.
Please refer to the descriptions below for
information on how the operating ele-
ments work.

Technical data

Cordless Compressor and Air
Pump ...................... PKA 20-Li C3
Rated voltage U .. 20 V ⎓ (direct current)
Weight with battery (20 V, 4 Ah)
....................................................... ≈2.2 kg
Max. air output
– Compressor ............................. 21 l/min
– Air pump ............................... 380 l/min
Max. pressure (Compressor)
..................................... 10,3 bar (150 psi)
Sound pressure level (L
.................................... 62.7 dB; K
Sound power level (L
– Measured ........82.7 dB; K
– Guaranteed ................................. 86 dB
Battery ............................................... Li-Ion
28
)
pA
=3 dB
pA
)
WA
=2.84 dB
WA
Temperature ..................................≤50 °C
– Charging .............................. 4 – 40 °C
– Operation ........................−20 – 50 °C
– Storage ................................ 0 – 45 °C
PARKSIDE Performance Smart
battery Smart PAPS 204 A1/
Smart PAPS 208 A1
– frequency band ...2400–2483.5 MHz
– transmitted power ................. ≤ 20 dBm
Use hearing protection!
Levels of noise and vibration were de-
termined according to the standards and
regulations in the declaration of conform-
ity.
The specified total vibration value and
the stated noise emission value have
been measured according to a stand-
ardised test method and can be used to
compare one power tool with another.
The specified total vibration value and
the stated specified noise emission value
can also be used for a provisional assess-
ment of the load.
WARNING! The vibration and
noise emissions may deviate from the
specified values during actual use of
the power tool, depending on how the
power tool is being used. Try to keep
the exposure to vibrations as low as pos-
sible. An example of a measure to re-
duce vibration exposure is limiting the
working hours. All parts of the operating
cycle have to be considered while doing
so (for example, times when the power
tool is switched off and times when it
is switched on but running without any
load).