Additional Safety Instructions; Preparation; Control Elements; Checking The Charge Status Of The Battery - Parkside Pka 20-Li C3 Instructions D’origine

GB MT
packs should only be performed by
the manufacturer or authorized ser-
vice providers.
Additional safety instruc-
tions
• Starting the motor is prohibited at low
temperatures below 0 °C.
• Avoid heavy loads on the piping sys-
tem by using flexible hose connec-
tions to avoid kinks.
WARNING! All hoses and fit-
•
tings of compressors must be suitable
for use at the maximum permissible
pressure.
• We recommend providing feed hoses
with a safety cable, e.g. a wire rope,
at pressures above 7 bar.
• The maximum inclination of the com-
pressor is 0 degrees.

Preparation

WARNING! Risk of injury due to
unintentional start-up. Only insert the re-
chargeable battery into the device once
the device is fully prepared for use.

Control elements

Familiarise yourself with the operating
elements before using the device for the
first time.
• Button ➖ (3)
Compressor: Reducing the set pres-
sure
• On/Off switch (4)
• Press briefly: Switch on
device; change pressure unit
34
• Press for approx. 5 s until
LCD display is off: Switching
off the device
• Button ➕ (5)
Compressor: Increasing the set pres-
sure
• Toggle switch (6)
◀ Air pump mode
○ Middle position
▶ Compressor mode
• LED button (9)
Switch the LED work light (10) on or
off.
• Lever (12)
Lever open
Checking the charge
status of the battery
1.
Press the button (20) next
to the charge level indicator
(21) on the battery (19).
The charge level of the battery is in-
dicated by illumination of the corres-
ponding LED lights.
red, orange, green
Battery charged
red, orange
Battery partially charged
red
Battery needs to be
charged
Lever closed