Machine Set-Up - Dewalt 237-Os Manuel D'instructions

ENGLISH
To prepare the machine for use follow this procedure:
1 Familiarize yourself with the machine. Read all danger, warning,
and caution statements and the Operator's and Parts Manual
before operating the machine. If you or the operator are unable
to read English, have this manual fully explained before
attempting to operate this machine.
2 Attach the handle to the base machine by following these
instructions:
A. The handle label should be pointing towards the front of
the machine and the black iron casting should drop down
into the top of the base machine securely.
B. Snap the three latches down to the base machine. The
hooks on the latches should slip over the keepers that are
attached to the base machine. The latches should require
a slight push to snap them into place (See Figure 3).
C. Plug the cord at the bottom of the handle into cord coming
out of the machine base and slightly twist to lock it in place
(See Figure 3A).
3 Install or replace sandpaper. The sandpaper should be replaced
if it is ripped, torn or the hook material is too worn to allow
attachment of sandpaper. To install or replace the sandpaper
follow these instructions:
A. Make sure the power cord is not connected to a wall outlet
or any power source.
B. Lock handle in the upright position.
C. Tilt the machine back until it fully rests on the handle.
D. While kneeling and facing the bottom of the machine,
remove the existing sandpaper (See Figure 4).
E. Press the new sandpaper against the grip face until the
hooks in the driver have set into the sandpaper
(See Figure 4A).
F. Return machine to the upright position.
CAUTION:
Damage to the grip face on the driver will occur if the machine is
operated without sandpaper installed.
CAUTION:
Always store the machine with sandpaper installed on all of the
drivers to prevent damage to the grip face.
WARNING:
Never put yourself or let others be in a position to get injured if the
machine should tip or fall while replacing the pad or changing
abrasive.

MACHINE SET-UP

8
Figure 3
Figure 3A
Figure 4
Figure 4A