Quick Start Instructions; Weighing A Patient - Health O Meter PROPLUS 4560 Mode D'emploi

SET UP / TRANSPORT
Preparing the Scale for Transport
The scale can easily be folded for movement from one room to another and includes pins on one ramp, to
carry the indicator. To prepare the scale for transport, follow these steps:
1. Fold both ramps--left and right (A) onto the platform while the scale is on the floor (see Figure 3).
2. Place the indicator (B) onto the pins on one of the folded ramps by sliding the slots that are on the
back of the indicator onto the raised pins.
3. Lift the scale onto its side by pulling up on the handle (C). The scale will now be ready to transport,
rolling on its wheels (see Figure 4).

QUICK START INSTRUCTIONS

Additional, complete instructions regarding all of the display and keypad functions and menus
can be found in the ProPlus
NOTE: This scale will always default to the settings and units last used, when it is turned on.
1. Make sure there is no object on the weighing platform.
2. Press the ON/OFF or I/O button to turn the scale on.
3. Wait until ""0.0 lb" and "ZERO" on the left side of the display appear.
4. Roll the patient onto the scale. The scale will calculate the patient's weight but the display will not show a weight
until the stable weight of the person is determined. Depending on the movement of the patient on the scale, it
may take several seconds for the scale to lock onto the weight.
5. Once a weight has been displayed, while the patient is still on the scale, we recommend performing a second
weighing by pressing the REWEIGH button.
6. After the weight measurement has been taken and is recorded, roll the patient roll off the scale.
7. Press the ON/OFF or I/O button to turn the scale off.
Figure 4
®
Display Module User Manual included with this scale.

WEIGHING A PATIENT

Figure 3