Honda Power Products UMC425E Manuel De L'utilisateur page 33

7.Attachment installation/removal
Check the joint area :
1.Check if the set pin knob moves smoothly.
2.Check if the joint knob tightens and loosens smoothly, and if there is
no any damage.
3.Make sure there is no debris in the groove and inside the joint holder.
Installation:
The engine shall not be started until the attachment is attached to the
power head. Otherwise, injuries might occur, for example, when your
fingers touch the joint opening.
1.Put the set pin knob to the lock position and loosen the joint knob.
2.Align the "
align the key of the attachment with the joint groove.
JOINT HOLDER
PROJECTION
2
LOOSEN
30
" mark on the attachment with the joint projection. Or,
SET PIN KNOB
1
LOCK
JOINT KNOB
(Back side of the portion
where the attachment is
connected)
3
ATTACHMENT
JOINT HOLDER
GROOVE
KEY