Encryption; Signaling; Quiet Talk (Qt)/ Digital Quiet Talk (Dqt) - Kenwood TK-5220 Mode D'emploi

ENCRYPTION

Note: You must install the Secure Cryptographic Module (SCM) to
use the Encryption feature.
Press the key programmed as Encryption, or access the
Menu {page 12}, to switch the transceiver to secure (encrypted)
transmission.
• Pressing the PTT switch after the Encryption function has been
turned ON encrypts the transmitted signal.

SIGNALING

■ Quiet Talk (QT)/ Digital Quiet Talk (DQT)

Your dealer may have programmed QT or DQT signaling on
your transceiver channels. A QT tone/ DQT code is a
sub-audible tone/code which allows you to ignore (not hear)
calls from other parties who are using the same channel.
Operator Selectable Tone (OST)
If a key has been programmed with OST, you can
reprogram the QT/DQT settings on each of your channels.
1 Select your desired channel.
2 Press and hold the key programmed as OST for
1 second.
3 Press
• Your dealer can set up to 40 tones/codes.
4 Press
5 When you have fi nished operating using OST, press the
OST key again to turn the OST function OFF.
■ Network Access Code (NAC)
Your dealer may have programmed a Network Access Code
on your transceiver channels. NAC is a feature of P25
transceivers that functions similar to QT/DQT; squelch will
open only when the correct NAC is received.
22
/ to select your desired tone or code.
to save your new setting.