Applications; Battery Removal/Installation; Prior To Operation; How To Use - Hitachi FDS 10DT Mode D'emploi

OPTIONAL ACCESSORIES (sold separately)
1. Battery (FEB7)
2. Plus driver bit
Bit No.
No. 2
3. Minus driver bit
a
0.8 mm
4. Hexagon socket (for nuts and bolts)
Socket No.
7
8
5. Drill bit for steel
Diameter, 2 mm, 5 mm, 6 mm.
6. Drill bit for wood
Diameter, 10 mm, 13 mm.
Optional accessories are subject to change without
notice.

APPLICATIONS

Driving and removing of machine screws, wood
screws, tapping screws, etc.
Drilling of various metals.
Drilling of various woods.

BATTERY REMOVAL/INSTALLATION

1. Battery removal
Hold the handle tightly and push the battery latch
to remove the battery (see Figs. 1 and 2).
Screw size
3 – 5 mm
Screw size
4 mm
Screw size
4 mm
5 mm
Socket No.
CAUTION
Never short-circuit the battery.
2. Battery installation
Insert the battery while observing its polarities (see
Fig. 2).
CHARGING
Before using the driver drill, charge the battery as
follows.
1. Insert the battery in the charger.
Position the battery so that the nameplate faces
toward the nameplate of the charger and press in
the battery until it comes into contact with the
bottom plate. (See Figs. 1 and 3)
2. Connect the charger power cord to the AC outlet.
Connecting the power cord will turn on the charger
(the pilot lamp lights up).
CAUTION
If the pilot lamp does not light up, pull out the
power cord from the AC outlet and check the
battery mounting condition.
About 1 hour is required to fully charge the battery
at a temperature of about 20°C. The pilot lamp goes
off to indicate that the battery is fully charged.
CAUTION
If the battery is heated due to direct sunlight,
etc., just after operation, the charger pilot lamp
may not light. At that time cool the battery first,
then start charging.
3. Disconnect the charger power cord from the AC
outlet.
4. Hold the charger tight and pull out the battery.

PRIOR TO OPERATION

1. Setting up and checking the work environment
Check if the work environment is suitable by follow-
ing the precautions.

HOW TO USE

CAUTION:
Before installing batteries, make sure that the
reversing switch is in neutral position. (See Fig. 4.)
1. Confirm the cap position (see Fig. 5)
The tightening power of this unit can be adjusted
according to the cap position, at which the cap is
set.
(1) For using the unit as a screw driver, set the cap
white line to one of the numerals "1" to "5" on
the outer frame.
(2) For use as a drill, set the white line at the drill mark
" " (see Fig. 5).
CAUTION
Set the cap white line at one of either the numerals
or drill marks.
2. Tlightening power adjustment
(1) Tightening power
Tightening power should correspond in its intensity
to the screw diameter. When too strong power is
used, the screw head may be broken or be injured.
Be sure to adjust the cap position according to the
screw diameter.
English
5