Gaggenau RB 282 705 Manuel D'utilisation Et D'entretien page 15

Operating the appliance on the appliance itself always
¡
takes priority. It is not possible to operate the appliance
using the Home Connect® app during this time.
10.1 Setting up Home Connect®
Requirement: The appliance receives signals from the
WLAN home network (Wi-Fi) at its installation location.
Scan the following QR code.
1.
You can install the Home Connect® app and connect
your appliance via the QR code.
Follow the instructions in the Home Connect® app.
2.
10.2 Checking the signal strength
You should check the signal strength if no connection
could be established.
Press .
1.
The temperature display (refrigerator compartment)
a
shows "Cn".
Press / ⁠ (Refrigerator compartment) repeatedly until
2.
the temperature display (refrigerator compartment)
shows "SI".
The temperature display (freezer compartment) shows
a
a value between "0" (no reception) and "3" (full
reception).
Note: The signal strength should be at least "2".
Improving the reception
If the signal strength is too weak, the connection may be
interrupted.
Carry out one of the solution options:
▶
Place the router and refrigerator closer together.
‒
Ensure that the connection is not interfered with by
‒
screening walls.
Install a repeater to strengthen the signal.
‒
10.3 Installing updates for the Home
Connect software
The appliance searches for updates to the
Home Connect® software at regular intervals.
Note: If updates are available, the temperature display
(refrigerator compartment) shows "UP".
To reset the update and the temperature display
(refrigerator compartment) to the set temperature, press
any touch field.
Press .
1.
The temperature display (refrigerator compartment)
a
shows "Cn".
Press / ⁠ (Refrigerator compartment) repeatedly until
2.
the temperature display (refrigerator compartment)
shows "UP" and the temperature display (freezer
compartment) shows "OF".
Press ⁠ (Freezer compartment).
3.
The temperature display (freezer compartment) shows
a
an animation.
The update is installed.
a
The control panel is locked during the installation.
a
If the installation is successful, the temperature display
a
(freezer compartment) shows "On".
If the temperature indicator (freezer compartment)
4.
shows "Er", the appliance was unable to install the
update.
Repeat the process at a later point.
‒
If the update cannot be completed after several
5.
attempts, contact customer service → Page 23 .
10.4 Resetting the Home Connect® settings
If your appliance experiences connection problems with
the WLAN home network (Wi-Fi) or your appliance wants
to log into a different WLAN home network (Wi-Fi), you
can reset the Home Connect® settings.
Press .
1.
The temperature display (refrigerator compartment)
a
shows "Cn".
Press / ⁠ (Refrigerator compartment) repeatedly until
2.
the temperature display (refrigerator compartment)
shows "rE" and the temperature display (freezer
compartment) shows "OF".
Press ⁠ (Freezer compartment).
3.
The temperature display (freezer compartment) shows
a
an animation for approximately 15 seconds.
The temperature display (freezer compartment) shows
a
"OF".
The Home Connect® settings have been reset.
a
Home Connect® en-us
15