DeWalt DW723 Guide D'utilisation page 6

WARNING: For your own safety, read and understand the miter
saw instruction manual before using. Failure to heed these warnings
may result in personal injury and serious damage to the miter saw
and the accessory.
13. The miter saw MUST be positioned so all four corners can be
bolted squarely to the mounting brackets. If this is not possible,
please call D WALT Customer Support at 1-800-4-D
E
(1-800-433-9258) for technical assistance.
NOTE: If the saw mounting holes do not line up with the slots in
the mounting brackets, mount the saw to a piece of 3/4" (19 mm)
plywood. The plywood must be a minimum of 4" (101.6 mm) wider
than the miter saw base being mounted and a minimum depth of
1" (2.5 mm)
MINIMUM OF
16" (406.4 mm)
15"
MUST BE AT
((381 mm)
LEAST AS
BOTH
DEEP AS THE
SIDES
SAW BEING
MOUNTING
1" (2.5 mm)
WALT
E
WIDTH OF SAW + 4" (101.6 mm)
1" (2.5 mm)
MOUNT MITER
SAW IN SHADED
AREA
16" (406.4 mm). Plywood must be at least as deep as the saw
base being mounted. Place the mounting brackets on the stand and
mount the plywood board to the mounting brackets exactly as shown
in figure. Drill 3/8" (9.4 mm) holes 1" (2.5 mm) from each end to
secure plywood to mounting brackets. Other hardware (not supplied)
may be necessary under these circumstances. NOTE: All purchased
hardware must be a minimum of Grade 2. Hardware should be
1-1/4" (31,8 mm) longer than the saw base you are assembling.
NOTE: If the saw mounting holes do not line up with the slots in
the mounting brackets and the method of utilizing plywood does not
accommodate your saw, please call 1-800-4-D
9258) for additional hardware to install your miter saw.
3/8" (9.5 mm)
DIAMETER
HOLES, ALL
4 CORNERS
3/4" (19 mm)
2" (50.8 mm)
PLYWOOD
MINIMUM
BOTH SIDES
1" (2.5 mm)
4
WALT (1-800-433-
E
SAW
BASE
FLAT
WASHER
LOCK
NUT
WASHER