DeWalt DW723 Guide D'utilisation page 4

ASSEMBLY
Work Stop/Support
a. The work stop/support has a clamp
(B) to capture the beam and keep
it from being knocked off the beam
by your material. The knob may be
locked by turning clockwise and
the work stop/support is free to be
repositioned when the knob is
turned counterclockwise. Do not
overtighten, firm pressure on the
knob will hold the stop in place.
b. Adjust the height of the work stop/support by loosening the
knobs on both sides (C) and raise or lower the top surface to
align with a straight edge or level to the saw table. Tighten the
bolts.
C
D
c. The work stop/support (D) can also be installed in the end cap
(E) at the end of the extension arms.
d. The length stop (F) may be rotated up to serve as a length stop
or hold the end of long work pieces.
B
E
D
F
Adjustable Length Extension Arm
To lengthen the support surface, turn the beam
lock knob counter clockwise to release the
extendable support arm. Pull the extendable
extension arm out to the desired length. Turn
the knob clockwise to lock.
Miter Saw Mounting
WARNING: To reduce the risk of injury, turn unit off,
disconnect machine from power source before assembling the
miter saw to the miter saw stand. An accidental start-up can cause
injury.
WARNING: Stability Hazard. You must use the plywood mounting
method detailed in step 13 when mounting a miter saw not
manufactured by D WALT to this miter saw stand.
E
WARNING: To reduce the risk of personal injury, be sure the
miter saw is fully anchored on the stand.
WARNING: For your own safety, read and understand the miter
saw instruction manual before using. Failure to heed these warnings
may result in personal injury and serious damage to the miter saw
and the accessory.
1. Place saw in operational position with blade facing you. Align
with label on the mounting bracket showing front.
2. Place a spacer, such as a 2 x 4, under one side of the miter saw
to hold the saw's mounting feet above the work surface.
3. Hold a mounting bracket under the saw and feed a carriage bolt
(hardware bag) up through the bracket and the foot of the saw.
NOTE: See DW723 Mounting Procedure Chart for the correct
mounting hardware procedures for D
all instructions properly, otherwise the miter saw's table rotation
will be obstructed.
2
WALT miter saws. Follow
E