DeWalt DW723 Guide D'utilisation page 3

Defi nitions: Safety Guidelines
The definitions below describe the level of severity
for each signal word. Please read the manual and pay
attention to these symbols.
DANGER: Indicates an imminently hazardous situation
which, if not avoided, will result in death or serious injury.
WARNING: Indicates a potentially hazardous situation
which, if not avoided, could result in death or serious injury.
CAUTION: Indicates a potentially hazardous situation which,
if not avoided, may result in minor or moderate injury.
CAUTION: Used without the safety alert symbol indicates a
potentially hazardous situation which, if not avoided, may
result in property damage.
IF YOU HAVE ANY QUESTIONS OR COMMENTS ABOUT THIS OR
ANY D WALT TOOL, CALL US TOLL FREE AT: 1-800-4-D
E
(1-800-433-9258)
Miter Saw Stand with Folding Legs
DW723
This stand is designed for use with most miter saws. If you have
any problem with alignment or mounting, call 1-800-4-D
(1-800-433-9258).
WARNING: For your own safety, read the miter saw
instruction manual before using any accessory. Failure
to heed these warnings may result in personal injury and
serious damage to the miter saw and the accessory. When
servicing this tool, use only identical replacement parts.
Tools Required
1. Socket or wrench set
2. Drill with 3/8" (9.5 mm) drill bit (Not required for D
Saws)
3. Phillips #2 screwdriver
General Safety Instructions for Miter
Saw Accessories
WARNING: To reduce the risk of personal injury:
• ALWAYS use eye protection. All users and bystanders must
wear eye protection that conforms to ANSI Z87.1.
• DO NOT exceed the weight this stand can hold. The main center
beam of the miter saw stand is designed to support 500 lbs.
(227 kg.) safely in a work environment. It is unsafe to climb, sit or
stand on the stand.
• Follow the mounting instructions carefully. Fasten the tool to the
saw mounting brackets securely as instructed.
• DO NOT modify or use stand for operations for which it is
WALT
unintended.
E
• DO NOT use the stand on uneven surfaces. The stand is
designed to be used on a flat, stable surface.
PREPARATION
Lay the miter saw stand on the floor with the
folded legs on top. Push the locking pin and
WALT
E
pull each leg up until the locking pin (A)
clicks into its detent. Lift the stand by the
center beam and place it in an upright
position. The stand should be stable and
should not rock. Check the legs to be sure
that the locking pins have engaged and the
legs are firmly held in place.
1
WALT Miter
E
A