Beko RFSA240M41SN Instructions D’utilisation page 18

EN
Electrical requirements
Before inserting the plug into the wall
socket make sure that the voltage and
the frequency shown in the rating plate
inside the appliance corresponds to your
electricity supply.
We recommend that this appliance is
connected to the mains supply via a
suitably switched and fused socket in a
readily accessible position.
The plug has to be accessible after
installation in order to allow disconnection
of the appliance from the supply after
installation.
Warning! This appliance must be earthed.
Repairs to the electrical equipment may
only be made by qualified experts. If the
power cable is damaged, the
manufacturer or customer service must
replace it in order to avoid danger.
ATTENTION!
This appliance operates with R 600a
which is an environmental friendly but
flammable gas. During the transportation
and fixing of the product, care must be
taken not to damage the cooling system.
If the cooling system is damaged and
there is a gas leakage from the system,
keep the product away from open flame
sources and ventilate the room for a while.
WARNING - Do not use mechanical
devices or other means to accelerate the
defrosting process, others than those
recommended by the manufacturer.
WARNING - Do not damage the
refrigerant circuit.
WARNING - Do not use electrical
appliances inside the food storage
compartments of the appliance, unless
they are of the type recommended by the
manufacturer.
Instruction for use
WARNING - If the supply cord is
damaged, it must be replaced by the
manufacturer, its service agent or
similarly qualified persons in order to
avoid a hazard.
Transportation instructions
1. The appliance should be transported
only in an upright position. The packing
as supplied must be intact during
transportation.
2. If during the transport the appliance,
has been positioned horizontally, it
must not be operated for at least 4
hours, to allow the system to settle.
3. Failure to comply with the above
instructions could result in damage to
the appliance, for which the
manufacturer will not be held liable.
4. The appliance must be protected
against rain, moisture and other
atmospheric influences.
Important!
• Care must be taken while cleaning/
carrying the appliance not to touch the
bottom of the condenser metal wires at
the back of the appliance, as this could
cause injury to fingers and hands.
• Do not attempt to sit or stand on top of
your appliance as it is not designed for
such use. You could injure yourself or
damage the appliance.
• Make sure that the mains cable is not
caught under the appliance during and
after moving, as this could damage the
cable.
• Do not allow children to play with the
appliance or tamper with the controls.
Installation instructions
1.Do not keep your appliance in a room
where the temperature is likely to fall
below -15 degrees C (5 degrees F) at
17