SEFRAM 7352B Manuel D'utilisation page 49

Data Logger
You can record a lot of reading to memory in a long time, then
analyze and plot graph. The meter can store maximum 40,000
data in memory. The recorded data amount shows on the
secondary display.
The record rate can be set from 1 sec and 600 sec. The error
of timer is less than 3 seconds per hour.
To use data logger, move the blink cursor of menu to LOG
position, and press the ENTER button to enter mode. In this
mode, you can operate the below options :
Data Logger Options
Press ENTER button to start data logger. The
logger automatically records at regular intervals.
SAVE You can press ENTER button to pause data
logger, press again to continue. To stop data
logger, press CANCEL button to return.
You can press the ENTER button to review data
LOAD from memory. Press UP or DOWN button to select
data. Press the CANCEL button to return.
Press ENTER button to clear all data from
CLR
memory.
You can setup the record rate of logger.
RATE Press UP or DOWN button to select rate.
Press the CANCEL button to return.
Press ENTER button to review the maximum data
MAX
from memory.
Press ENTER button to review the minimum data
MIN
from memory.
To exit data logger, press the CANCEL button.
19