SEFRAM 7352B Manuel D'utilisation page 48

Memory Save / Load
When measuring, you can save the reading to memory and
load it from memory. The meter can store maximum
in memory. The recorded data amount shows on the
secondary display.
To use memory save / load mode, move the blink cursor of
menu to MEM position, and press the ENTER button to enter
mode. In this mode, you can operate the below options:
Memory Options
You can operate the Auto-Save mode to automati-
cally save new reading. When you use the probes
to measure a new reading, the meter will automati-
cally save it. In some case, the Auto-Save mode will
A-SAVE
not work. For example, the reading is smaller than
the limit (refer Auto-Hold), or the reading is OL.
Press ENTER button to start Auto-Save mode,
press CANCEL button to exit.
Press ENTER button to save a new reading to
SAVE
memory.
You can press the ENTER button to review data
LOAD from memory. Press UP or DOWN button to select
data. Press the CANCEL button to return.
CLR Press ENTER button to clear all data from memory.
Press ENTER button to review the maximum data
MAX
from memory.
Press ENTER button to review the minimum data
MIN
from memory.
To exit memory save / load mode, press the CANCEL button.
1000
18
data