19 Spare Parts and Accessories
The vibration levels indicated were measured according to a
standardized test method and can be used as a basis for
comparing electric power tools. The vibration levels actually
occurring may vary from the values indicated, depending on
the type of application. The vibration levels indicated can be
used for an initial estimate of the vibration stress. The actual
vibration stress has to be estimated. The times when the
electric power tool is switched off and the times when it is
switched on but running under no load can be taken into
account in the estimate.
For information on compliance with Employers' Vibration
Directive 2002/44/EC see www.stihl.com/vib.
18.4 REACH
REACH is an EC regulation and stands for the Registration,
Evaluation, Authorisation and Restriction of Chemical
substances.
For information on compliance with the REACH regulation
see www.stihl.com/reach.
19 Spare Parts and Accessories
19.1 Spare parts and accessories
These symbols indicate original STIHL spare
parts and original STIHL accessories.
STIHL recommends the use of original STIHL spare parts
and accessories.
Despite ongoing market observation, STIHL is unable to
judge the reliability, safety and suitability of other
manufacturers' spare parts and accessories; accordingly,
STIHL cannot warrant for the use of those parts.
Original STIHL spare parts and original STIHL accessories
are available from STIHL dealers.
0458-005-9621-A
20 Disposal
20.1 Hedge Trimmer
Contact your STIHL servicing dealer for information on
disposal.
► Dispose of the hedge trimmer, accessories and packaging
in accordance with local regulations and environmental
requirements.
21 EC Declaration of Conformity
21.1 Hedge trimmer STIHL HSA 94 R, HSA 94 T
ANDREAS STIHL AG & Co. KG
Badstraße 115
D-71336 Waiblingen
Germany
declares under our sole responsibility that
– Category: Cordless hedge trimmer
– Manufacturer's brand: STIHL
– Models: HSA 94 R, HSA 94 T
– Serial number: 4869
conforms to the relevant provisions of Directives
2011/65/EU, 2006/42/EC, 2014/30/EU and 2000/14/EC and
has been developed and manufactured in compliance with
the following standards in the versions valid on the date of
production: EN 55014-1, EN 55014-2, EN 62841-1 and
EN 62841-4-2.
Applied conformity assessment procedure in accordance
with Directive 2000/14/EC, Annex V.
HSA 94 R, cutting length 600 mm
– Measured sound power level: 94 dB(A)
English
51