Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
PAYMENT SYSTEM
Using special kits, the machine can be fitted with payment
systems with MDB protocol.
The payment systems must be housed in the special side
module (optional).
SALE PRICES
A different programmable price can be set for each selec-
tion;
the standard setting has the same sales price for all
selections.
WATER SUPPLY
From the mains, with a pressure of 7.3 to 123.3 psig (0.5
to 8.5 bar).
AVAILABLE ADJUSTMENTS
Time adjustment for water and product doses.
Water temperature adjusted via software.
CONTROLS
- Presence of water
- Operating temperature reached
SAFETY DEVICES
- Main switch
- Door switch
- top panel switch
- Presence of solid waste tray
- Presence of liquid waste container
- Manual-reset boiler safety thermostat
- Instant boiler float jam
- Overflow solenoid valve
- Double temperature relief valve for anti-boiling function
- Timer protection for:
Pump
Coffee (tea) doser device for Fresh-brew
- Overheating protection for:
Doser units
Magnets
Pump
Electric mixers
- Fuse protection for
Main electrical circuit
Board power supply transformer
© by N&W GLOBAL VENDING SpA
CAPACITY OF CONTAINERS
Fresh coffee
Chocolate
Milk
French Vanilla
Tea
POWER CONSUMPTION
The machine power consumption depends on many fac-
tors, such as the temperature and ventilation of the room
where it is installed, the inlet water and boiler temperature,
etc.
With an ambient temperature of 22° C the following power
consumption levels resulted:
To reach operating temperature
For 24 h in stand-by
The above power consumption calculated from average
data should only be taken as an indication.
ACCESSORIES
A wide range of accessories can be installed on the
machine to vary its performance:
The installation kits are supplied with their own installation
and test instructions, which must be strictly observed to
ensure the machine safety.
Important notice!!
The use of kits which are not approved by the manufacturer
of the vending machine does not guarantee compliance
with safety standards, especially for energised parts.
The manufacturer declines all responsibility for the use of
non approved components.
Installation and the following testing operations must
be carried out exclusively by personnel who have a
specific knowledge of the machine functions from a
point of view of electrical safety and health regula-
tions.
4
350 g
700 g
600 g
700 g
400 g
317
Wh
1850
Wh
0603 265 - 00
Publicité
Table des Matières
