Surfing Mode; Filler Menu; Statistics - N&W Global Vending Koro Manuel D'utilisation, Installation Et Entretien

SURFING MODE

The interaction between system and user occurs through
the following components:
- Liquid crystal display (LCD) 2 lines of 16 characters.
- External direct selection push-button panel which takes
on the following functions when in "Filler" and "Techni-
cian" mode (see Fig. 20):
Fig. 20
Scrolling buttons " " and " ":
To move to the next or previous menu option and change
the values (up or down).
Confirm button " ":
To move from a menu to a sub-menu, or to confirm the
current information on the display.
Exit key " ":
to return from a sub-menu to the higher level menu, or to
clear the data on the display.
It is also used for going from "Technician" mode to "Filler"
mode and vice versa.
Fig. 21
1 - Mechanical counter
2 - Wash button
3 - Programming access button
4 - Push-button card cover
© by N&W GLOBAL VENDING SpA

FILLER MENU

When pressing once the programming button located on
the push-button card, the machine goes into "Filler menu"
mode.
The display presents the first item of the "filler" menu with
a series of numbers next to it, identifying the level of the
current menu.
Press the confirm button " " to access the menu.
Press the exit button " " to return to the previous menu.
FILL>

STATISTICS

STATISTICS
All data concerning sales and the machine operations is
stored in both total counters and relative counters, which
can be reset without losing total data.
Printing
Connect an RS232 serial printer having a Baud rate of
9600, 8 data bit, no parity, 1 stop bit to the serial port located
on the push button board to print all of the statistics.
The printout will also contain the machine information, the
date and the software version.
To connect the printer, do as follows:
- press the confirm print button " ", displaying the mes-
sage "Confirm?";
- connect the printer before confirming;
- press the confirm button " " to start printing.
Displaying
Press the confirm button " " to display in a sequence the
same data obtained with the statistic printing, for both total
and relative counters.
Deleting
Statistics can be reset for relative counters globally (all
types of data) or selectively for:
- selections
- failures
- coin mechanism data
Press the confirm button " ", and the message "Confirm?"
starts blinking.
Press the confirm button " ", the message "Working" is
displayed for a few seconds and all statistics are reset.
17
FILL>
Print statistics
FILL>
Display statistics
FILL>
Reset statistics
0603 265 - 00