Controls And Information; Loading Instant Products; Service Functions - N&W Global Vending Koro Manuel D'utilisation, Installation Et Entretien

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

CONTROLS AND INFORMATION

The machine should operate at an ambient temperature of
2°C to 32°C.
The user controls and information are located on the
outside of the door (see Fig. 4).
The labels with the selection menu and the operating
instructions supplied with the machine must be inserted at
the time of installation, referring to the selection dose table.
Fig. 4
1 - Jug support tray
2 - Jug filling nozzle (FB plus only)
3 - Machine lock
4 - Logo label
5 - Alphanumeric display
6 - Selection menu label
7 - Selection buttons
8 - Dispensing spouts
9 - Tilting cup support
10 - Liquid waste tray
11 - Float signal
The Programming button, to access the machine func-
tions, and mixer cleaning button are located inside the
machine on the right-hand side of the push-button card.
In order to access the programming menus, press the
programming button located on the push-button card.
At this point the machine goes into Filler menu mode.
The selection buttons are now used for surfing through
the different menus.
NOISE LEVEL
The continuous, weighted equivalent acoustic pressure
level is below 70 dB.
© by N&W GLOBAL VENDING SpA

LOADING INSTANT PRODUCTS

Open the machine top panel and lift the container lids, fill
the single containers with the appropriate products, taking
care not to compress them to prevent packing. Make sure
the products do not contain any clots. Carefully close the
lid, ensuring it is properly secured.
Fig. 5

SERVICE FUNCTIONS

Some operations, if enabled from the programming menu,
can be carried out directly with the door closed entering a
password (pressing 5 buttons in a sequence) after press-
ing button 7 for more than two seconds.
The possible operations are as follows:
- consecutive dispensing of several selections in a jug
(jug facilities);
- free dispensing of a selection;
- keypad operation lock/unlock. With the keypad lock
on, the display will indicate "SUSP. SERVICE"
- Mixer wash. The operation must be carried out daily
and every time the machine is refilled to prevent
clogging of the mixer if any product is accidentally
spilled during refilling.
6
Fig. 6
0603 265 - 00

Publicité

Table des Matières
loading

Table des Matières