Notes On Programming; Power; Operating Modes; Normal Operating Mode - N&W Global Vending Koro Manuel D'utilisation, Installation Et Entretien

Notes on programming

The machine electronic control allows or not the use of
many functions:
All of the available functions are described in the machine
program, including the ones that are not used for the
specific configuration of the model (layout).
The machine is supplied with a dose table, describing the
different functions and layouts available for the specific
model and the flowchart of the programming menu.
Below is listed a summary explanation of the main func-
tions useful for managing the operation of the machine, not
necessarily in the order in which they are displayed in the
menu.
For further information and detailed explanations refer to
the programming manual available through our sales
organisation or at our after-sales service.
The software version can be updated using the specific
systems (PC, Flash, UpKey etc.).
The messages on the display that indicate the current
operation
are fixed, while any action required by the user is blinking.
POWER ON
Before switching the machine on, ensure that the grounds
trays and the container lids are into place.
Each time the machine is switched on, the display shows
the following message:
POWER ON
Press any selection button to continue.
It is possible to program the machine to enable the function
that displays the controls to be performed before starting
the machine, and namely:
Tubing (nozzles etc.)
Mixers
Powder feeder
Power on
For all controls the request "Confirm?" is indicated on the
display.
Press any selection button to continue.
The function of presenting the list of preliminary controls
can be enabled (disabled by default) from the program-
ming menu.
At the end of the power on cycle, the display indicates the
software version number to which referring for consulting
the programming manual.
Press any selection button to continue.
The machine can be programmed for displaying, for a few
second, the number of selections made.
© by N&W GLOBAL VENDING SpA
Confirm?
Koro FB
REV 1.0

OPERATING MODES

The machine can be in three different operating modes.
According to the operating mode, the buttons take on
different functions.
The available operating modes are as follows:

Normal operating mode

Filler menu
Technician menu
NORMAL OPERATING MODE
During the normal operating mode the display shows the
message for the user with the prompt to select the drink.
The function of the buttons can be different according to
the layout and to the choices made during programming.
When inserting coins in a payment system, the available
credit is displayed.
Credit=
During the drink dispensing, also a status bar is shown,
indicating the drink preparation status.
In the event of a malfunction detected by the control
system, an error message will be displayed indicating the
type of problem.
SELECTION NOT AVAILABLE
At the end of dispensing, the display indicates for a few
seconds the request to pick up the drink and the machine
is preset for the next selection.
16

FUNCTIONS

Coins accepted
products dispensed
Test dispensing
machine maintenance
Programming
different parameters
SELECT THE DRINK
SELECT THE DRINK
0.50
DRINK SELECTED
"Failure name"
DRINK READY
TAKE
0603 265 - 00