Installing The Payment System; Water Softener Unit; Inserting The Labels - N&W Global Vending Koro Manuel D'utilisation, Installation Et Entretien

INSTALLING THE PAYMENT SYSTEM

The machine is sold without payment system, there-
fore the installer of such a system is responsible for
any damage to the machine or to things and persons
caused by faulty installation.
Payments systems such as validators, "change-giver" and
"cashless" can be installed by using the specific kits.
Payment systems such as "change giver" must be physi-
cally housed in the special side module (optional).

WATER SOFTENER UNIT

The machine is sold without water softener.
Should the mains water be very hard, a 2-litre ion-ex-
change resin water softener unit can be installed in the
cabinet.
The water softener, available as accessory, must be
replaced or regenerated regularly following the directions
from the manufacturer.
For health and functional reasons, higher capacity water
softener units should not be used.
In the event of water supply from the tank, the special
filtering cartridges can be used.
The cartridges must be replaced periodically according to
the water quality and to the instructions from the manufac-
turer.
INSERTING THE PRODUCT LABELS
The menu and instruction labels are supplied with the
machine and must be inserted at the time of installation
according to the layout and to the language (see "selection
dose" table).
To access the label insertion slots, remove the side cover
of the door, secured with two screws.
Fig. 17
1 - Side cover
2 - Fastening screws
3 - Selection menu label
4 - Slots for inserting the labels
5 - Logo label
© by N&W GLOBAL VENDING SpA
POWER ON
Before switching the machine on, ensure that the grounds
trays and the container lids are into place.
Each time the machine is switched on, the display shows
the following message:
Press any selection button to continue.
It is possible to program the machine to enable the function
that displays the controls to be performed before starting
the machine, and namely:
Tubing (nozzles etc.)
Mixers
Powder feeder
Power on
For all controls the request "Confirm?" is indicated on the
display.
Press any selection button to continue.
The function of presenting the list of preliminary controls
can be enabled (disabled by default) from the program-
ming menu.
At the end of the power on cycle, the display indicates the
software version number to which referring for consulting
the programming manual.
Press any selection button to continue.
The function of presenting the list of preliminary controls
can be disabled from the programming menu.
The machine can be programmed for displaying, for a few
second, the number of selections made.
After a few seconds the display shows the message:
SELECT THE DRINK
13
POWER ON
Confirm?
Koro FB
REV 1.0
0603 265 - 00