Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
When overheating and engine seizure occurs do the following:
• Remove spark plug lead and spark plug cap..
• Remove screw (F) from the cylinder cover.
• Remove bottom right (G) and bottom left (G) screws from cylinder cover.
• Carefully pull cylinder cover forward, pull ignition lead and flameout lead
and lay aside.
• Loosely install spark plug cap to keep debris out of the cylinder. Use brush to remove
dirt from cylinder fins.
Important: Do not use a metal scraper to remove dirt from the cylinder fins.
• Assemble components in reverse order.
Note: When installing the cylinder cover, the stop switch lead is seated in the rubber
grommet.
Engine problems due to inadequate lubrication caused by failure to use an ISOLEGD
and J.A.S.O. FC certified oil will void the two-stroke engine warranty. (Emission related
parts only are covered for two years, regardless of two stroke oil used, per the
statement listed in the Emission Defect Warranty Explanation.)
Fuel to oil mix 30:1 ratio
Gas in Liter
120
240
600
Handling Fuel
Warning! Fuel is very flammable. Use extreme care when mixing, storing or
handling or serious personal injury may result.
● Use an approved fuel container.
● Do not smoke near fuel.
● Do not allow flames or sparks near fuel.
● Fuel tanks/cans may be under pressure. Always loosen fuel caps slowly allowing
pressure to equalize.
● Never refuel a hedge trimmer when the engine is hot or running!
● Do not fill fuel tanks indoors. Always fill fuel tanks outdoors over bare ground.
● Do not overfill fuel tank. Wipe up spills immediately.
● Securely tighten fuel tank cap and close fuel container after refueling.
● Inspect for fuel leakage. If fuel leakage is found, do not start or operate hedge
trimmer until leakage is repaired.
● Move at least 3m (10 ft.) from refueling location before starting
Oil in cc.
4
8
20
51
Publicité
Table des Matières
