Mounting The Handle And Operating Knob; Preparing The Connection To The Flue - Dovre 100CBS Installation Et Mode D'emploi

1. Tip the stove from the side.
2. Fit the four legs (1) on the studs (4) using the wash-
ers (2) and the M8 nuts (3) that are found on the
bottom plate.
3. Set the appliance upright on the mounted legs.
Support the appliance when placing it upright
so that not all the weight is not on the legs.
Mounting the handle and
operating knob
Secure the handle using the M6x20 screw supplied (2)
to the front piece and the operating knob for the air reg-
ulator (1); see following figure.
10
Preparing the connection to
the flue
When connecting the appliance to the chimney you
have the choice of connecting via either the side, the
rear or the upper side. See the paragraphs "Con-
necting on the side or to the rear" and "Connecting to
the upper side". It is also possible to make a con-
nection via the attachment 5T that can be ordered sep-
arately; see the paragraph "Connecting via the
attachment".
A special connection collar is required to connect
to the upper side of the appliance.
The appliance is not supplied with a flue gas open-
ing.
Sealant and materials supplied.
Connecting to the side or the rear
First of all, choose whether to connect the appliance
to the flue from the side or the upper side or the rear.
The appliance can only be connected in pos-
ition 1, 2, or 3; see following figure.
Subject to change because of technical improvements