Installation; Preparation; Mounting The Legs - Dovre 100CBS Installation Et Mode D'emploi

Installation

Preparation

Please check the appliance for damage caused dur-
ing transport or any damage or defects immediately
after delivery.
If you detect transport damage or any other
damage or defects, do not use the appliance
but notify the supplier.
Remove the detachable parts (vermiculite interior
plates, baffle plate) from the appliance before you
install it.
By removing removable parts, it is easier to
move the appliance and to avoid damage.
Note the location of the removable parts, so
that you can re-position the parts in the correct
place later on.
Removing inner plates
Vermiculite inner plates are light and tend to be
ochrous in colour on delivery. They insulate the
combustion chamber to boost combustion.
Cast iron inner plates protect the combustion
chamber and dissipate heat to the sur-
roundings.
Follow the instructions below to remove the inner
plates; see following figures.
1
2
Subject to change because of technical improvements
1. Pull forward the inner plate (4) at the bottom and
2. Slide the inner plate at the top of the appliance for-
3. Push the plate upwards so that you can tip it diag-
4. Lower the plate to the bottom in the space.
5. Remove the plate from the appliance using the
6. Tilt the inner plate (2) from both sides and remove
7. Remove the rear plate (3) from the appliance using

Mounting the legs

Fit the legs to the appliance; see the following figure.
4
3
09-20020-255
remove it via the door opening.
wards (1).
onally.
door.
the plate from the appliance using the door.
the door.
09-20020-256
9