During Operation; Switching Off - Dirt Devil EVO PLUS Mode D'emploi

6 Use

6.4 During operation

WARNING:
Danger of injury! The appliance works auto-
matically and quietly. Always take care not
to step on, stumble over or fall over the
appliance.
NOTE:
If the integrated batteries have to be
charged, a short melody sounds, the appli-
ance drives back to its starting point, parks
and turns itself off. Then proceed as
described under ZChapter 4.3, "Charging
the appliance".

6.5 Switching off

NOTE:
If your cleaning robot has completed a
room and returned to the starting position, it
goes into standby mode for about five min-
utes. (A continuous blue light is emitted
from the on/off button
27
.) It is not yet off.
NOTE:
You can always stop the appliance during
the cleaning process by pressing any key or
lifting the robot. In both cases the cleaning
mode button flashes (
appliance saves the cleaning progress.
You can then continue the cleaning process
by pressing the flashing cleaning mode but-
ton again ( or
switch off the robot by the on/off button
it loses its virtual map and begins again after
being turned back on.
NOTE:
If no buttons are pressed when the cleaning
robot is in standby mode, the appliance
goes into sleep mode (the status LEDs light
up blue periodically one after another). It is
still not off.
1. Turn off the cleaning robot by pressing the
on/off switch for 2 seconds.
2. Remove the cleaning panel.
3. Make sure you remove the dirty and pos-
sibly wet floor cloth from the cleaning pan-
el.
4. After having used the wet cleaning panel,
empty it completely and leave the water
tank cap open so that the panel can dry
completely.
5. If, before turning the appliance off, its on/
off switch flashed red, charge its inte-
grated batteries, ZChapter 4.3, "Charging
the appliance".
6. If the control cube has not turned itself off,
switch it off at its on/off switch
or ) and the
). However, if you
,
.
47