Use; Switching On The Appliance - Dirt Devil EVO PLUS Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

6 Use

5.4 Preparing the room to be cleaned
WARNING:
Danger of injury! Ensure that no children or
pets are in the room or have access to the
room to be cleaned.
WARNING:
Danger of a short circuit! Do not use the
appliance on floors with recessed sockets.
ATTENTION:
Remove pointed and sharp objects from the
floor that could scratch surfaces if they got
under the cleaning panel of your EVO.

6.1 Switching on the appliance

6
Use
ATTENTION:
Although your cleaning robot recognises
drops in elevation, we strongly advise
against using it on furniture and similar
objects. It is not suitable for this type of use.
21
44
ATTENTION:
Your EVO PLUS has a powerful drive. Do
not underestimate its power. Put into a safe
place objects that are fragile or could topple
or fall over if the appliance drives into them.
Also remove cables, drapes, curtains and
the like from its range to avoid damage and
to prevent unnecessarily impeding the
cleaning process.
NOTE:
The EVO PLUS is not a vacuum cleaner
and its floor cloth can only remove a small
amount of dust. Clean particularly dirty
rooms with a vacuum cleaner beforehand.
ATTENTION:
Never operate the cleaning robot without a
floor cloth attached. Otherwise, surfaces
might be damaged.
1. Put the cleaning robot on the floor to be
cleaned near the control cube.
2. Turn on the cleaning robot using the on/off
switch
(Fig. 21).
- A continuous blue light is emitted from
the on/off button
- A short melody sounds.
- The left status LED flashes blue until
you
select
a
ZChapter 6.2, "Wiping up dust" or
ZChapter 6.3, "Washing".
- If you do not select a cleaning mode, the
appliance will turn itself off after about
five minutes.
.
cleaning
mode,

Publicité

Table des Matières
loading

Table des Matières