Caractéristiques - Hpi Racing Tf-45 Manuel D'instructions

Specification Caractéristiques
Eigenschaften
If any parts are damaged or missina
FallsTeile beschädigt sind Oder f emen, k ontaktieren SiebittedieServiceabteilung.
Veujllez Si des piéces sont endommagées
hpi•racing
Transmitter TF-45
• System : 3CH
(Steering, Throttle, Push switch)
• Frequency : 2.4GHz
• Radio wave type : FHSS
• Battery : AA x4
• Weight : 450g
Sender TF-45
• System: 3 Kanal
(Lenkung, Gas, Druckschalter)
• Frequenz: 2.4GHz
• Sendemodus: FHSS
• Betriebsspannung: 6V (4xAA)
• Gewicht: 450g
FCC COMPLIANCE STA TEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable
residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the operating
however, there is no guarantee that interference
cause harmful interference to radio or television reception, which can be determined by tuming the equipment off
and in, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equiprnent into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced
This device cornplies with Part 15 of the FCC Rules and with RSS-210 of Industry Canada Operation is subject to
the following two conditions:
1)This device may not cause harmful interference, and. -
2)This device must accept any interference received, including interference that may cause undesired operation
WARNING: Changes or modifications made to this equipment not expressly approved by the party responsible for
compliance may void the FCC authorization to operate this equipment
RF Exposure
Statement The TF45 transmitter has been tested and meets the FCC RF exposure guidelines when used with the
accessories supplied or designated for this product, and provided at least 20cm separation between the antenna the
users body is maintained- Use of other accessories
Receiver RF-45
• Frequency : 2.4GHz
• System : 3CH
• Fail Safe (LiPo or NiMH battery type switch)
Battery : (NiMH 6V or 2 cell 7.4V Lipo)
• Size : 33x26x13mm
• Weight : 8g
Empfänger RF45
• Frequenz: 2.4GHz
System : 3CH
• Fail-Safe (Akkutypschalter: LiPo - NiMh)
• Akku: 6V NiMh oder 2-Ze11en
Größe: 33x26x13mm
• Gewicht: 8g
contact customer service.
ou manquantes,
www.hp&æb.g.com Mw.hpi-eumpe.com
HA USA HPI Eurcpe
70 Imn 19 WiGrn Nadh WOY,
Roth" Ranch, CA 92610 USA
(94) 7531099 DEII cæ, UK
(888)3494474 C.Lßbm«
Émetteur TF-45
• Systéme : 3 voies
(direction, accélération,
• Fréquence : 2,4 GHz
• Type d'ondes radio : FHSS
• Piles:6V
• Poids : 450 g
TF45
3CH
• : 2.4GHzÆ
• : FHSS
: 450g
protection
instructions, rnay cause harmful interference
will not occur in a particular
technician for help.
may not ensure compliance
Récepteur RF-45
• Fréquence : 2,4 GHz
• Systéme : 3 voies
• Sécurité (Interrupteur pour batterie de type Li-Po ou NiMH)
• Batterie: (NiMH 6Vou
• Dimensions : 33x26x13mm
• Poids : 8g
RF45
• : 24GHzw
• 714
• : NiMH6VJOy-Y-lJ—.
7.4V LiPo
• : aax26x13mm
veuillez contacter Ie service clients.
12
www.hp&æb'g.co.»
HA Japan
105.
Harnarnatsu-±i,
Derbyshi-q
Y,jzuoka-ken 4350028
Commutateur poussoir)
blJfl--.
against harmful interference in a
to radio communications,
installation. If this equipment does
with FCC RF exposure guidelines.
2 cellules 7.4 V Lipo)
Lip02t2JV7AV
wwwhp&æbw.neLcn
HPI China
BOI02, No.68 Guar-gt-,zn Rd.
unharv Diüict, SharVJai,
JAAN Chha 201108
(+86)150-0093-2860
Vol.1 105425