Cleaning And Maintenance - Imetec R5301 Instructions Pour L'utilisateur

Tropical program
The Tropical program is for those who want the maximum heat during the night. It can be
selected directly via the Alexa app or voice command, or by pressing the Program selector
button (6); the Tropical program LED (10) will light up. Once 8 hours have elapsed since the
launch of the program, the control device will switch off automatically.
If the temperature or timer is modified while the Tropical program is active, the program will
be interrupted and the control device will begin working with the new settings.
ADJUSTING THE LED BRIGHTNESS
To prevent the display lighting from disturbing your rest, the brightness of the LEDs is
automatically reduced about 15 seconds after any button has been pressed. The LED
brightness level can be adjusted via the Alexa app or voice command.
RESTORING THE FACTORY SETTINGS ON THE CONTROL DEVICE
To reset the control device, proceed as follows:
• Disconnect the control device from the mains supply
• Simultaneously press and hold the Temperature selector button (7) and the Timer selector
button (15). At the same time, plug the control device into the wall socket, keeping the two
buttons pressed until the Wi-Fi LED (11) flashes three times.
SWITCHING OFF
Switch the heated mattress cover off by pressing the ON/OFF button (7) and remove the plug
from the socket (3).
The heated mattress cover is washable. Check the washing symbols on the label to
ensure it is washed correctly.
WARNING! Always disconnect the appliance from the mains
and disconnect the control connector from the underblanket
before cleaning or performing maintenance.
BEFORE WASHING
• Take the plug of the control unit cable out of the mains socket (3).
• Press the grip levers at the sides of the control unit connector (2) to remove the control
unit connector from the heated mattress cover connector (1).
MACHINE WASHING
• The heated mattress cover can be cleaned in the washing machine at 30°C, on a delicate cycle.
• Use only the delicate cycle for spinning. DO NOT make an additional spinning cycle.

CLEANING AND MAINTENANCE

EN
24